IV. Specifications
4) Wall Mount, aim to left:
ED100
ED200
Remove the iron case from the
supporting bracket by using screw
driver to loosen the two screws,
which connect the iron case to the
supporting bracket. Turn the iron
case in 90-degree and mount into
the supporting bracket again by
changing the screw holes in order
to keep the screw indicator on the
top side.
ED100 Series
ED200 Series
Pickup Device:
Picture Element:
1/3 inch B/W interline 1/3 inch Color
transfer CCD
interline transfer CCD
510x492(/E,EIA)
500x580(/C,CCIR)
510x492(/N,NTSC)
500x580(/P, PAL)
Horizontal resolution: 420 TV lines (EIA)
400 TV lines (CCIR)
380 TV lines (NTSC)
340 TV lines (PAL)
Sensitivity:
0.5 lux/F=2.0
Over 48 dB
Up to 1/10,000
> 0.45
2.5 lux/F=2.0
Over 48dB
S/N ratio:
INSTRUCTION
MANUAL
qConnect the video output of the camera to a B/W monitor
(ED100) or a color monitor (ED200), or other video device
through a 75 ohm type coaxial cable with BNC female
connector at cable extension.
Electronic shutter:
Gamma Correction:
Video output:
Power source:
Up to 1/100,000
0.45
1.0Vp-p,75 ohm
1.0Vp-p,75 ohm
rConnect the DC+12V regulated power source to the DC12V
12VDC+/-10%,
150mA Max.
12VDC+/-10%,
250mA Max.
Power-in jack with 2mm, center+, outer- plug.
Sync. Mode:
Lens Mount:
Dimension:
Internal Sync.
M12xP0.5
Internal Sync.
M12xP0.5
sPut the dome plastic cover back into the Dome Camera.
106mm Dia.x 85mm H.
106mm Dia.x85mm H.
o
o
o
o
Operating Temperature: -10 C to +50 C
-10 C to +50 C
|